Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Cisco1751Image is 12.2-8T Voice, VPNThe router didn't take my caller id commands under the voice ports.Does anyone know if Caller ID is supported on 1751's?ThanksMike
Hi,I was curious if there was a rule of thumb on the # of users that the AP-350 could support until we should go get a new one and set it up on a different channel. Our users are not corporate users; mainly browsing www and email.ThanksMike
Hi,Since there isn't any IDS functionality on a Cisco827, is there any way to log ACL permit or denies to a syslog server from activity on the outside interface? I am trying to keep an eye on port scanners and any activity on the outside interface o...
Hi,I was hoping someone could help me configure IDS on an 827. I will attach a copy of the config below. We are using a syslog server.The book I am reading tells me to use these three commands:ip audit notify logip audit name ids info action alarmi...
Hi,I was hoping to get some assistance in differentiating between the 4800-B and 4800-E.I noticed in a posting below that states:"The 4800 had two models. The 4800, and the 4800b. If you have a B model is it identical to the Cisco 340 series. If you ...
I don't think that they will reset to 0 on their own. It also don't believe it is possible to clear the hit counts via a specific command.The only way I am aware of is by removing and re-applying the ACL via the access-group command.Thanks,
Original Poster (anperry),You may want to take this information to your cisco account team as it contradicts Cisco's EOS announcement for the 1105 found here:http://www.cisco.com/en/US/products/sw/cscowork/ps3915/prod_bulletin09186a0080184940.htmlThi...
check to see if your pix is tail dropping syslog messages from its queue:show logging queueyou can increase the queue if you need to. Also, make sure you aren't logging to the console or buffer. Only log to your syslog server.