Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I'm currently seeing interface ethernet2 on my pix 515e as Admin Down, Line Protocol Up.Could someone pls explain why a PIX does this?? Is it just because its detecting layer 2 connectivity??
Hi,could someone please explain the following to help me understand how it works??I have 2 routers connected via a serial p2p link and configured with /30 ip's at both ends. If I connect to 1 router and ping its own local WAN interface, the ping requ...
Hi,I have a pix515E and am trying to connect directly to it to upgrade the software to 6.3(5). I have configured my PC to be in the 10.132.0.x network with an 8 bit mask. I connected a cross-over cable to the PIX's inside interface and configured the...
Hi,With a PIX, I believe that each access list match is on a 'per tcp flow' basis not on a 'per matching packet' basis. Is this the same for routers or do routers match on a per packet basis??Thanks
Hi Pavan,Sorry, my mistake. It was the path cost that was set to 4 and it was set on the ILM2 interface that goes out to Core2. The ILM2 interface connecting to ILM1 had a path cost of 3 by default and we left this as is.
Hi Jon,I had the subnet masks checked by 3 different people and all confirmed that it was okay. It is just an 8 bit mask. We doubled checked the interface and confirmed that it is the correct one. We can see it up/up and removed the crossover cable a...
