Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I normally try to do my best to solve this problems by myself. But right now I'm out of ideas abut it.I'm using a HTTP Trigger to get information for placing outbound calls to other phones, then I need to play different prompts to the called party...
Hi, I need to know if it's possible to validate a single FAC for a period of time.I mean, can I enter my FAC only the first time when I dial a specific Pattern and then make the system to store the dialed FAC for a couple of minutes? Our client PBX d...
Hi Everyone!I have the following doubt:Is the 1242 able to support point-to-multipoint? I haven't found information regarding this particular feature, tell me if you have already configured a point-multipoint 1242Thnks
Hi Netpros!I'm trying to use my AS5350 as a voice gateway and I have not found usefull information regarding this topic.What I have so far is the following:(attached document)Right now I receive the call from the E1, but the AS is not handling the ca...
Hi,A have the following scenario:5 vlans configured on my AP, 3 of them use PEAP to authenticate users (not computers), I'm using ACS 3.3.3 connected to my Active Directory.The thing is, How can I filter access from one SSID to another if I am using ...
Simon,Could you please explain me how should I configure the dialog groups correctly, I was searching for a complete explanation about it but I haven't found anything yet.
The UCCX version is 7.0(1)_Build168.I tried the following:Just to be sure that the result of the place call step is "successful" I placed a "Play Prompt" step for both, the triggering contact and the outcall contact. The curious thing is, the system ...
does the switchport also belongs to vlan 1?is there an ...interface vlan 1,ip address X.X.X.X sm.sm.sm.sm,no shut... configured on the switch?check if the dot1q trunk is recogniced by the switch with "show int trunk"
