Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am looking to find out the proper configuration for three ports on two 3750X switches to have an isolated network / VLAN that will NOT talk to any other network / VLAN in my environment and only needs internet access. I have two interfaces on one s...
I have a Zyxel Firewall performing all the routing on my network which includes several VLAN's(VLAN10, 20, etc. I am having a disagreement with the vendor. The only way their device supports VLAN routing you have to set the profile up and map it to a...
Hi All,I am not a stranger to Cisco Switches, but a newbie to VLANs and have had some confusion with them. I am trying to implement a 9800 wireless lan controller. but I am putting it on hold until I get all my Vlans Setup correctly.I have a total of...
Hello,I am new to the Cisco Self Standing Wireless LAN Controller System. I have always used Mobility Express, and I know it is end of life. The purpose of this AP is for learning and using it in my home lab. I have read this post below:Migrate ME to...
I have a 3750G switch that is booting, but is booting up garbage when it boots up. I can not boot to prompt or even configure the switch. I was working before I turned it off and used it at another site. Now I have a switch that turns on and fully bo...
@Mark Elsen That is perfect!!! It worked just fine. Did all my testing and everything FINALLY works. All profiles, tags, SSID's, and WLAN's are perfect. Windows DHCP is a bit tricky with 9800 WLC, but I figured it out (Required some DNS Entries, but ...
@Mark Elsen Thanks Mark. I appreciate it. Why doesn't it show up in my config though. When I run "show config" command I do not see the "wireless management interface Vlan10" line in my config that is what is so confusing, but I have ran it. Thank yo...
@Mark Elsen I have the exact config minus a couple differences I highlighted in "RED". with comments as well. See below:interface GigabitEthernet1 - Correctdescription OOB-Management - My Descriptionno switchportvrf forwarding Mgmt-intf - Correctip a...
@Mark Elsen That is the thing and trying to explain I did configure it correctly per the standards and it was working before I onboarded an AP and got the SSID's to work and was able to connect clients, but I wanted to perform a fresh install, but I ...
@Mark Elsen I am just trying to prove a theory of mine. The old controller setup had the service port - OOB Management on Vlan10 and the WMI on VLAN100. I then decided when I make the new controller, I swapped the service port Vlan which was VLAN10 t...
