Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Helloi have 10 Nexus 5672 switch , all same version of IOS with blank config, while 7 pcs boots and acts normally, other 3 pcs are too slow , it takes more than 15 minutes to boot , also after bootup, entering a write mem command take almost one minu...
Hello,there is some Excel sheets for each wireless product named as power channel data rate table, here is a sample which is for C9115AXI series :https://www.cisco.com/c/dam/en/us/td/docs/wireless/access_point/channels/reference/r17-6-x/9115axi-pwr-c...
Helloi have a C9115 wifi access point model C9115AXI-E-K9 , in datasheet Cisco said it has 4-dbi 5ghz and 3-dbi 2.4 Ghz integrated antenna but in configuration page gain of antenna is set to 10 and it is gray and not changeable , is that really 10? i...
Hello,For getting regulatory approval in special project, my customer did some tests on C9115AXI-E with EWC installed and they report fail result!i guess something on configuration caused failure.according to standard table 4.2.6.2.2 both beginning a...
Helloi have a Cisco C9115 Access Point with embedded controller , i tried booting with several POE switches such as 2960S and 2960X and even 9200 series but while in some cases it boots normally in some other cases it seems device is not working prop...
good day and thank you yes it is strange , as most of other modes of radio ( other columns in Excel sheet ) are in italic, so why for a radio it supports DFS on for example 40 and 80 Mhz channel size while it doesn't have DFS on HT20 mode!and if 9115...
Hello Rasika,thank you for your reply.in that Excel sheet, it said "DFS channels are in Italic"as i checked and you can see as well, for my case- channel 52 ( freq. 5260 ) numbers are NOT italic, while for channel 100 it is italic, so result of my te...
Hellothank you for the comment, but no one from Cisco here to say why this mistake happened in many releases of the controller software? and does it affect on actual power or it is just a typo mistake? because a lab tested my device and reported that...
Hello Richard,thank you for sharing your advise on this, but what do you think about the DFS test? may the Smart-DFS feature cause this issue? or can it be because of high channel bandwidth ( i. e. 40 , 80 or 160 Mhz ) ? i appreciate if you check the...
Hello,thank you in advance, but as per laboratory engineer reported , they changed country to AE and result was same. i know product has UAE approval but this is for special project that they do their own test - i don't know how this product get appr...
