Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Estoy en el diseño de un proyecto donde estoy proponiendo la utilización de switches cisco 3750 y 4507. Tengo la inquietud acerca del funcionamiento de estos switches en las localidades debido a que en el datasheet de los equipos indican el parámetro...
I want to deploy the following scenario:My Telephony Service Provider give me a Digital E1 (30-channels PCM) on Main Site and I want to receive them with a router and VWIC-1MFT-E1 to transmit via ethernet to another site with other router with VWIC-1...
I have two routers, a Cisco 1760 Router with Advanced Security features and 12.4 IOS version, and one Vyatta Router VC.5.0.2. They are ethernet connected and they have full convergence. For IOS version Issues, I had that changes the Cisco Router 1760...
I have a problem my frame-relay point-to-point network: Actually, the primary site equipment is a Cisco 2801 ISR and the remote site is Cisco 1005 and with this deployment full service working satisfactory but when I do change the 1005 router por Cis...
I am going upgrade my Cisco 3660 Router by one Cisco 3845 ISR, I need Firewall Feature Set in my new router but I have to use the NM-1A-E3 used actually. Is compatible the CISCO3845-SEC/K9 Bundle with IOS Advanced Security for the NM-1A-E3 module? Th...
Hello Giuseppe. Thank you very much for your help.The critical problem is that the transport medium for voice traffic will be satellite link and how you understand that is a very expensive medium reason for what I require as much as possible reduce b...
Hello oliv98.I resolved the problem, it was compatibility issue of onboard NIC of my PC. I tried with another motherboard and the results were satisfactory with the same configuration.Greetings,Daniel.
Hello Giuseppe and very thank you for your help.I resolved the problem, it was compatibility issue of onboard NIC of my PC. I tried with another motherboard and the results were satisfactory with the same configuration.Greetings,Daniel.
I was experimenting with different operating systems and found that with a version 12.4 The OSPF process converge satisfactorily but I now have the detail that the process is restarted every 40 seconds with the resulting exchange of information betwe...
Hello Giuseppe.I have verified mtu issue and they are equal at interfaces of two routers (cisco 1760 and vyatta). Annexed it is file with debug ip ospf adj.The ospf process stuck in INIT state.A1760>sh ip ospf neigNeighbor ID Pri State ...
