Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there some switch configuration that will improve multicast UDP data for a cisco switch?I am working on a program that uses a large amount of multicast traffic as distributed simulation data using a Catalyst 2960G switch. I have observed sufficie...
Can someone recommend a switch that supports 4096 multicast groups?I am working on a system that includes over a dozen catalyst 2960 switches. The customer has pointed out the 2960 switch does not satisfy the requirement to support 4096 multicast gr...
I am unable to access a series of switches connected together through a management vlan. I receive the message "The server xx.xx.xx.xx at level_15_access requires a username and password." Entering the username and password fails and the same usern...
I am looking for a minimal baseline switch configuration to use setting up a set of switches.The process now is to reset the switch to factory defaults, assign an ip address with switch/telnet password. Then telnet to the switch and manually enter c...
Reza,Thanks for the suggestion and refrenced documentation link. I did have ip http server enabled, however, I did not have ip http authentication aaa specified. Including that command accepted the same username and password used for ssh access.Th...
