07-05-2012 08:53 AM - edited 03-07-2019 07:37 AM
I am unable to access a series of switches connected together through a management vlan. I receive the message "The server xx.xx.xx.xx at level_15_access requires a username and password." Entering the username and password fails and the same username and password message returns. I am able to ssh into the switch with the username and password that fails trying to access the switch with the browser.
How can I check the username and password for access with the browser?
I am trying to monitor switch performance. Is there a good way to monitor switch performance with the command line interface?
Thanks in advance,
---d.dembrow
07-05-2012 09:00 AM
Hi,
Have you enabled "ip http server" an the switch?
http://www.cisco.com/en/US/docs/ios/12_1/configfun/command/reference/frd1005.html#wp1020224
HTH
07-05-2012 10:10 AM
Reza,
Thanks for the suggestion and refrenced documentation link. I did have ip http server enabled, however, I did not have ip http authentication aaa specified. Including that command accepted the same username and password used for ssh access.
Thanks very much,
---d.dembrow
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide