We are trying to set up a GateKeeper on a Cisco 7206 to route voip calls between two gateways. I would like to be able to do this WITHOUT registering the gateway endpoints. I have been unsuccessfull in my attempts to get this to work. Here is our Ga...

The Conf soft key on the 7935 doesnt work. We have 6 of these things(7935) and none work. We have 100s of 7960s and the conf feature works fine on them. This is the software in the conf station:Software Version: 3.1S Protocol Type: SCCP Boot Load I...

Just a little FAQ for those of you trying to do paging with Avvid.You need a VG200 with a FXS card. We are using Bogen as our third party paging/intercom solution. Set the paging hardware to station/co. Set your FXS voice-port to ground start. We...

I need to configure a Vg200 with FXS ports to work with a Bogen intercom system. Im currnetly using CallManager with 7960s and 7910s and I need the ability to page thru this system. I need 4 diferent zones. Can you give some examples of this type ...

When I start the softphone on my laptop I dont see any lines to control. I verified all points in trouble shooting. What now?