Gateway to gatekeeper config.......HELP!

[guckengc]

We are trying to set up a GateKeeper on a Cisco 7206 to route voip calls between two gateways. I would like to be able to do this WITHOUT registering the gateway endpoints. I have been unsuccessfull in my attempts to get this to work. Here is our Gatekeeper config:

gatekeeper

zone local gk anyco.com

no zone subnet gk default enable

alias static x.x.x.x 1720 gkid gk gateway voip ras x.x.x.x 1719 e164 53*

alias static x.x.x.x 1720 gkid gk gateway voip ras y.y.y.y 1719

gw-type-prefix 53* gw ipaddr y.y.y.y 1720

no shutdown

Here is the originating gateway. config.

dial-peer voice 53 voip

destination-pattern xxxxxx01153T

translate-outgoing called 1

voice-class codec 1

session target ipv4:GATEKEEPER ip

dtmf-relay h245-alphanumeric

All we are doing here is placing a call from our IVR into the gateway which strips the auth code(xxxxxx) and 011 then passes the call over to the gatekeeper. When I try and place a call here is what I get, this is a "sh call hist voice" from the gateway:

PeerAddress=5372040288

PeerSubAddress=

PeerId=53

PeerIfIndex=619

LogicalIfIndex=0

DisconnectCause=3

DisconnectText=no route to destination.

I did this on the gatekeeper as well and it doesnt show anything.

So what am I doing wrong here?

Thanks for your help!

[guckengc]

correction:

alias static x.x.x.x 1720 gkid gk gateway voip ras x.x.x.x 1719 e164 53*

alias static y.y.y.y 1720 gkid gk gateway voip ras y.y.y.y 1719

gw-type-prefix 53* gw ipaddr x.x.x.x 1720

I got my x and y mixed up.

[tim.medley]

In your dial-peer you might want to change the session target to ras. I don't think you can specify the session target as the ip address of the gatekeeper.

If I get a chance, I'll set this up in my lab and try it out.

You may want to just open a TAC case on this issue, may get you a quick solution.

tm

Tim Medley, CCDP, CCNP+Voice

Sr. Network Engineer

Corliant, Inc.