Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, i have a simple 5506 firewall setup with two interfaces, inside 172.19.0.2/24 and outside 10.10.10.1/24 a partner has their firewall in the outside subnet 10.10.10.100/24I have one static route to reach my other internal subnets:route inside 1...
Hi, can someone clarify the EOL notice for Cisco Anyconnect v3;http://www.cisco.com/c/en/us/products/collateral/security/anyconnect-secure-mobility-client/eos-eol-notice-c51-734084.html I am interested in the date in which software updates for Securi...
Hi, i have a 2960 which i need to replace as it is now end of life, the replacement Cisco recommendes is the WS-C2960+24TC-L which is one of the new 260 Plus models, can you tell me if you can create a VLAN interface on this switch as it states that ...
Hi, we have serveral AIR-SAP1602I-E-K9 access points which are currently working in standalone mode, we now have a 2504 Wireless LAN controller so is it possible to convert the AIR-SAP1602I-E-K9 to lightweight mode?
Yes that is enabled. The partner can ping and access resources from their side but i'm unable to do anything my side. When i try to ping the outside interface of the ASA from the inside i get:
Failed to locate egress interface for ICMP from Inside
...
Hello, sorry that route was a typo. The firewall is configured with 1 static route is 0.0.0.0 0.0.0.0 172.19.0.1 on the inside
the below is my NAT config:
nat (Inside,Outside) source static Int_VDI Ext_VDI
nat (Inside,Outside) source static Int_A...
Hi, thanks for the info. Does it matter that in that Cisco documentation is doesnt specifically say this conversion process is supported for the 1602 AP?:"You can use an upgrade conversion tool to convert autonomous Cisco Aironet 1100, 1130AG, 1200, ...
