About sjpope40

sjpope40 · 10-04-2021

I accidently issued this command on a newly deployed Webex Pro codec: xconfiguration userinterface interaction: onscreen I was re-writing an AMX control module for an SX series codec and forgot to take that line out. I want to turn this off but I c...

sjpope40 · 07-30-2019

I have a remote site that has several IP phones behind a satellite WAN link. The RTT is around 700ms so the TFTP file transfers from the CUCM to the phones can take several hours to complete. Are there any options to speed up the file transfer spe...

sjpope40 · 07-15-2022

Randy - thank you very much, that was the command. We found this by accident right before I read this by looking at a factory reset codec and downloaded the config. This command is loaded into the default config. I hope this helps anyone else stuck i...

sjpope40 · 10-20-2021

Hello @Alex Stevenson I need the commands for the WEBEX CODEC Pro. This is the API that I am working off of: https://www.cisco.com/c/dam/en/us/td/docs/telepresence/endpoint/ce915/collaboration-endpoint-software-api-reference-guide-ce915.pdf The iss...

sjpope40 · 08-05-2021

I know this topic is three years old but this actually works out pretty well for my question - has this setup been stable for you? I have seen some instances of using the SX20 with third-party control and we lose connectivity regularly from our third...

Member Since	‎06-29-2009 07:22 PM
Date Last Visited	‎10-26-2022 12:03 AM
Posts	5
Total Helpful Votes Received	5

User Statistics

User Activity

Cisco Webex Pro, Disable Onscreen User Interface

Cisco Unified IP Phone Firmware Distribution over satellite link

Re: Cisco Webex Pro, Disable Onscreen User Interface

Re: Cisco Webex Pro, Disable Onscreen User Interface

Re: Room Kit Plus integration with third-party controller