I am about to place an order for a 2821 router but I need to be sure if i will able to install a 9- or 16-port HWIC to serve as layer 2 switch for the network I will setting up at my remote site.
There is this website that always capture the internal IP addresses of my network instead of the public IP address on the outside interface of the PIX firewall.Please, I need to stop this issue fast. Any suggestion?
I have just installed ciscoworks VMS but I have not been able to access any of the management centres. Each time I tried I get |This page cannot be displayed" error on my IE browser.
After installing Ciscowork VMS, I have been unable to load any of the installed management centres. When I tried loading ids-mc, the page tries to connect and then times out.Help fast.Ayo
I want to exclude some of my network's internal IP addresses as sources. This is a recommended action for some signatures fired on the AIP-SSM of my ASA.Pls, how and from which of the devices do I exclude the IP addresses.
Well if you say so but browsing on this website www.walahi.com which is an online bookshop and while trying to checkout brings out my host local IP instead of the outside interface IP as the case with www.whatismyip.com.
Yes. the config is belownat-controlglobal (outside) 1 interfacenat (inside) 1 172.19.0.0 255.255.0.0and there is a squid proxy server on network through which all internal hosts must pass through to the internet.
