Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I get this validation error when creating a new Pod (multipod) using the wizard.Validation failed: Infra vlan 4 is used by Domain uni/l3dom and in AEP uni/infra/attentp. Please remove infra vlan from vlan block or from AEP.This is in the Cisco ACI...
Hi,
We have the following setup
- AnyConnect NAM (4.9.6037) with ISE Posture (4.9.6037) & Compliance Modules (4.3.2099)
We would like to upgrade to ISE Compliance Module 4.3.4065.8192 on a few TEST machines without having to change the AnyConnect pr...
Hi,
Anyone successfully setup a cellular interface on ISR4K using NIM-LTEA-EA module and vManage?
I have the below config but i can't seem to get it to work.
!controller Cellular 0/1/0lte sim primary slot 1profile id 1 apn vodacom authentication pap_...
ScenarioWe have Ubuntu Linux based guest users connecting to the wired network and authenticating using the guest portal.In most cases the authorization matches the wrong authz policy as ISE doesn't seem to use the guest username and instead uses the...
Hi,
We were able to overcome this by using "ospf network point-to-point non-broadcast" and static neighbor definition between two contexts sharing same interface.
Hi Gibbs,After logging in to the Guest portal, we are expecting the below condition to match so that the correct authZ profile is assigned to the guest.IdentityGroup:Name EQUALS User Identity Groups:GuestType_Contractor_ABCBasically we are checking i...
Hi, I tried this within dcloud environment using ISE 2.7 p2. Initial AD join on CLI was successful but CLI based external accounts could not login. Solution was to disjoin AD from CLI and rejoin on both CLI and GUI.
