Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Have two cat6500 in VSS. With single SUP 720-10G in each chassis.
If I were to perform a redundancy force-switchover command to fail over to standby SUP which is in the other chassis.
1. What happens to the former active SUP. Is it reloaded?
2...
I will be replacing my firewall in the next few months and didn't want to do a forklift upgrade. I would rather install new firewalls to test before removing the old ones.
A watered down version of the current setup is the Core Switch does the routi...
I am upgrading our core switches from Cat 6506E to Nexus 56128P. The current setup is 2 6506E using VSS. So both switches are managed from 1 IP and all SVI created are on both switches. For example the host at the bottom of the picture I attached has...
Neither switch has EOL or EOS announced. But IOS XE 16.3.X is EOL https://www.cisco.com/c/en/us/products/collateral/switches/catalyst-3850-series-switches/eos-eol-notice-c51-740255.html
When changing from l2 to l3 the switch reboots and factory resets (besides being in l3). Did you try and console into switch to verify booting properly after factory reset. As well as vlan1 IP address?
Problem 1:What routing loop are you referring to?Are the red paths and green paths different subnets?What type of traffic do you want to analyze through the FW. Is it only certain protocols? Problem 2:If you are only using static routes you can use a...
Awesome thanks for the info. Just 2 quick question,that I'm just curius about.
1. If this was a single chassis with 2 SUPs not it VSS and I forced a switch over. Would it still reboot the chassis?
2. If I had quad SUP setup in VSS, 2 SUPs in each...
