Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All,
Can you please let me know whether I can run HSRP on C3650-48FD-L hardware with Lan base license
echnology Package License Information:
------------------------------------------------------------------------------Technology-package Technol...
Dear All,I am planning to purchase MX 250 firewall for my customer but what does below means1. Statefull firewall throughput (4Gbps)2. Advanced security throughput (2Gbps)3. Maximum site to site VPN throughput (1Gbps)
Dear All, I am trying to make a policy based IPsec tunnel with remote partner and below is the configuration. Do I need to configure the access-list inside and outside or I can skip them? crypto map IPSEC_map 80 match address ABCcrypto map IPSEC_map ...
Thanks for the Swift response.So if I am going to configure the VPN tunnels only on MX device without using the IDS/IPS/AMP features, in that case also the MX throughput will be limited to 1Gbps.Any Idea what will be throughput if MX device is having...
If I am not mistaken, If you see BGP routing table like sh ip bgp x.x.x.x, you will not see AD value in the output. That is self-explaintory it will not be used to make any comparison among BGP route.
Can you please shed some light below statment mentioned in the Document:sysopt connection permit-vpn will bypass ACLs (both in and out) on interface where crypto map for that interesting traffic is enabled, along with egress (out) ACLs of all other i...
Apologies, Can you please provide your expert comments on below both point more specifically To run IP SLA features on below router1.Primary router is MPLS (no security license)-> Do I need to buy appx license to run IP SLA features2. Back-up is Int...
