Hi All,
We have one UCS VIC 1225 10GBps card installed on slot 2 of the CISCO UCS C240 M4S server. OS is windows 2012 R2. We have installed proper firmware and driver but still we are unable to ping the IP configured on the VIC adapter.
We have t...
Hi,
Anyone tried with connecting ext USB drive to CISCO B200 M3 Blade. Could not seen USB port outside but as per architecture, these should be one internal port. If yes, how we can connect it online.
Regards,
Hi Team,
Below is our setup.
- CISCO C240M4
-Qlogic FC HBA 8 GB 2*2 Port
-SAN Storage.
We have enabled boot from SAN on all the qlogic 4 adapter of CISCO C240M4 Server and assign LUN ID 0 with 100 GB. Everything goes well until the Windows partition ...
Hi Team,
Below is our setup.
- CISCO C240M4
-Qlogic FC HBA 8 GB 2*2 Port
-SAN Storage.
We have enabled boot from SAN on all the qlogic 4 adapter of CISCO C240M4 Server and assign LUN ID 0 with 100 GB. Everything goes well until the Windows partition...
Hi,
Thanks for the reply.
I am configuring the IP on adapter on windows OS. I am using single vNIC port for the IP configuration. It is simple access port with VLAN ID 100 but still unable to make the connection. Physical port is up on the OS si...
