Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
Have a nice day.
I would like to inform you that our PRI link vendor provide this number "0255667788" but few call generate from unknown number like as "0355469788".
So our PRI Link vendor inform us block unknown number.
So Please help me...
Hi,
I would like to inform you that Recently I have configure cisco voice gateway and all incoming and outgoing call communication is establish.
But I have found that when I call from my cell phone to voice gateway IP telephone number then receive ...
Hi,
How are you everybody.
I would like to inform you that today I have integrate 9951 phone with ccum 10.5 .
But I can not enable Camera.
I already check the Accessories list from Phone there is no "Cisco Unified Video Camera"
So please anybody ...
Hi ,
I have facing some problem for IP Telephony system.
When I have call from outside on IP Telephony system like "+8809610127777" then DTMF and IVR tone working fine But after I have dial extension
number like "520" but call not transfer this exte...
Hi,
I hope you are all well!
I try to configure HSRP in cisco catalyst 3850-X series switch, But I can't configure HSRP cause the command are not there.
This is the Software version installed on it...
Switch Ports Model SW Version SW Image Mode --...
Hi Suresh,
Here after I have attached screen shot for your requirement.
Please see the attachment.
Your kind assistance shall be highly appreciated.
Thanks&Regards
Fozlarabbi
Hi Suresh,
I have cucm and used tcl sript.
Please let me how to check that dial plan is overlapping.
Here after I have attached file of voice gateway configuration.
Please see the attachment.
Your kind assistance shall be highly appreciated.
Tha...
Hi Deepak,
Thank for your replay.
I would like inform you that I have already connect camera in USB port but it does not enable.
I also inform to you when i connect camera into usb port then Show this message"Device is detected But administratively...
