Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi folks,Can anyone please advise if there is a finite number for the amount of routes that can populate the MX-100 routing table before routes are no longer reachable?For example, in our hub and spoke configuration, we have run into instances where ...
I am having an issue bring up certain interfaces on a C9500-48Y4C. The C9500 is a 2 switch stack and Stackwise virtual is configured.The interfaces that I am having issues with are on switch 2 of the C9500 chassis (Twe2/0/31 & Twe2/0/33) and are conn...
Hi AllI cannot get SSH enabled on a cisco950032QCcat9k_iosxe.17.09.05.SPA.confi have created a domain name, reset the cryptokey (crypto key zeroise) and generated a new key, yet ssh is disabledhostname#crypto key generate rsa modulus 2048% You alread...
Hi All, I am looking for advice on how to configure / physically deploy an active/passive fw configuration when the ISP are providing a HSRP virtual IP for MPLS connectivity.The same ISP provides 2 routers and a managed virtual HSRP IP. I was intendi...
Hi All, we are deploying a pair of C9500's configured as a stackwise virtual pair. Connected to these switches are multiple 4 switch 9300 access layer stacks with dual-homed multi ethernet-channels back to the 9500's. The uplink connections are typic...
On further investigation, it seems like the hub with the large routing table is receiving the same route from the other hubs in the network (ie the same subnet appears 5 times, each from a different hub), whereas a hub with the ‘expected’ route table...
