Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a service provider that has had multiple issues in the past with route oscillation (withdrawing routes and then injecting routes), causing the BGP total routes to fluctuate significantly and affect internet access. I'm working on an EEM that ...
I can't for the life of me get streaming video to work with stateful inspection. It looks like youtube is only using ports 80 and 443 for communication and I have those ports opened. Does stateful inspection inspect source or destination IP addresses...
This should be an easy question. For SSH access:Why does this work?Standard IP access list 2 10 permit 172.16.2.0, wildcard bits 0.0.0.3 log 20 permit 172.16.1.32, wildcard bits 0.0.0.31 (6 matches) 30 permit 208.x.x.0, wildcard bits 0.0.0.2...
I have a 3640a, 3550 and airopoint 350 I use for my home internet connection. I know it's old equipment, but it's all I could afford at the time. Directly plugged into my modem I get about 10 mb/s, plugged into a switch port no greater than 6, and ab...
I have a 3640 connected to a 3550 with an AP attached for my home network. My PC is in a wireless VLAN and XBOX on the wired. When both are on the wired they are able to discover each other and I am able to stream videos from my PC to my XBOX. When o...
Ok, thank you for the feedback. I'll do some research on what you mentioned and post back with further questions or when I have a working solution. Does Cisco have an example somewhere of this type of configuration that you know of?
Mike, You know, I was thinking the same thing, and it worked. I guess when you specify a transport layer protocol you don't have to specify the more specific protocols. I didn't think it would cause any problems though. I still need to troubleshoot w...
Yep CEF is up and running Globally. I have attempted to use an older IOS revision, different configs and interfaces with the same results. I was thinking of trying fast switching see if for some reason it gives me a performance boost. I doubt it.
Hobbe,Do you mean 50-70 Mb/s or is that in packets per second? Because after about 6,000 packets per second it really hangs up. The following is a list of the cards installed:NAME: "One port Fastethernet TX", DESCR: "One port Fastethernet TX"PID: NM-...
