Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 7925G that I am trying to use with CallManager 6.1.2. But the phone gets stuck at the registering stage. Like it keeps looping. I've downloaded the latest device pack and installed it. Any Suggestions?Not sure if this is related but when I s...
Here's my problem:I have a sup32 running in a 6513 switch running in native mode. My boot var is set to BOOT=sup-bootdisk:s3223-adventerprisek9_wan-mz.122-18.SXF8.bin and my config register is 0x02102.When I reload the switch autoboot tries to open ...
I saw where the 7921 phones can support Push To Talk functionality. Being a newbie to programming xml services I was wondering if anybody had any source code they could share to help me out. I've searched all over and basically found nothing except ...
Thanks for the response. Oddly enough I rebooted the appliance(CallManager) this morning and everything came up right. So everything is working now. When in doubt reboot.
When I check the Callmanager status on the phone it will go from active to not active back to active again the whole time it is looping trying to register.I checked the phones trace log and found this error repeating HERMIT user.err SCCP: no data[0]<...
I have this same problem. Only I initiated a switch versions from 6.1.2 to 6.1.1 and now when 6.1.1 comes up it gives me this error NoFeatureLicense. When I switch back to 6.1.2 everything works fine. Since I'm going back to 6.1.1 why do I get this e...
Thanks for the replyAfter several reload and reset commands I ended up powering the switch down and then back on. After I did that the autoboot statement worked. Go figure. But that still doesn't explain why it wouldn't work when I issued the reset c...
