Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello ,when installed a NM-16ESW module on cisco 3745 router ,the ports are considered switch ports ,because i got a msg:"% IP addresses may not be configured on L2 links." when i tried to give IP address for an interface on the module.so , i created...
Hello,if i need to debug the traffic of only one ip address on a cisco router , how can i do this??i know that an access list may be used , but please clarify the method for me?
Hi unfortunately ,this didn't work well on cisco 3745 router ,it does not accept the command "no switchport " ->incomplete command . I issued the command "no switchport mode" and "no switchport access vlan1"but also it gives the same message that can...
