Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have created a CBD probe in our Moncton, Canada office. The probe is connected to our Cisco Business Dashboard located in the Netherlands. However, it does not see any of my cisco devices (which are on the same network). Even when I add them manual...
We just installed 5 Meraki CW9164I Cloud Managed AP's. 2 of them show as the assigned name and the version number. The other 3 show as MR_CCT. This is not a big issue I am just curious as to why they would be different as they are all on the same fir...
While trying to remove a vlan from my spanning-tree line in error I created the line no spannin-tree vlan 18 as shown below:spanning-tree mode rapid-pvstspanning-tree extend system-idspanning-tree pathcost method longno spanning-tree vlan 18spanning-...
After completely configuring my Cisco 1300 switch, it takes forever to load the GUI and sometimes never does or gives me a message failed too long to respond. My version is up to date (v 4.10.0.87) and I have tried different browsers and incognito mo...
I am trying to create a port-channel on my Cisco 1300 switch stack. I have verified all the settings but still getting an error message when I add my interfaces to the port-channel. The error message is auto-negotiation/adv. capabilities of port te1/...
Hi Mark,The 9300L has another VLAN interface with a lower VLAN ID than VLAN 24 and that interface has an IP address. That is the issue. That IP is not in the same subnet from the probe. Thank you for this information.
Hi Mark,The Catalyst 1300 is fully managed in the CBD and I still am not seeing the Cisco 9300L. I know it won't be managed but I would like it to appear in inventory. Here is the screen shot of the CDP neighbors. Any thoughts?
Hi Mark,Answer to your questions: The probe is running on a VM in the Moncton office on the same VLAN 24 as all my devices.As you suggested I added the management VLAN 24 to the Bonjour Discovery Interface Control Table on my Cisco 1300 client switch...
So, the AP's have already been integrated into the cloud and like I said two of the AP's are showing their assigned names and 3 are showing MR_CCT. Again, not a big deal just trying to learn. Thank you.
Thank you. For now, I can live with it. I am in the middle of too many projects to worry about it. Just thought maybe someone had an idea of how to reverse this. I will try some of your suggestions when I get a chance. Thank you.
