Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
We are using Cisco 3750 switch where we have configured one port as SPAN port . The port is generating lot of output drops even we have QOS disabled glogablly, other ports are fine. We can see the traffic on the tool connected in the SPAN p...
I understand while we upgrade EPLD we need to reboot the nexus 9K switch for new version to take effect. we have 9k switch pairs in our network. since the traffic going over the switches, if we perform upgrade on switch , is there any way to move al...
Hi All,
Please share me the document/link for upgrading nexus 9396px switch. When i go through the cisco portal there are mostly mentioned upgrading supervisor module, but this one does not have it . so need help on it. Can we do ISSU or disruptive...
Hi All,
We have SSID which assigned with multiple vlans, so when the users are accessing the wireless network through radius authentication , they will be assigned to any one of the VLAN to get network access. There is a new requirement to add two w...
Hi All,
Can anyone answer my question. I want to take data regarding total number of connections per seconds and ssl connections per seconds from ACE4710-K9 load balancer, we are using Solarwinds NPM for monitoring, we are collecting date to migra...
We have configured this interface as SPAN port, so this SPAN port connected to Gigamon TAP device which will send mirrored traffic to Netscout for packet analysis. When i look at Netscout we see the vlans sent from SPAN session created in 3750 switch...
I just tried it but still an output drops increasing,
GigabitEthernet1/0/14 is up, line protocol is down (monitoring) Hardware is Gigabit Ethernet, address is 2834.a220.678e (bia 2834.a220.678e) Description: SPAN MTU 1500 bytes, BW 1000000 Kbit/sec...
Please check the below output,
GigabitEthernet1/0/14 is up, line protocol is down (monitoring) Hardware is Gigabit Ethernet, address is 2834.a220.678e (bia 2834.a220.678e) Description: SPAN MTU 1500 bytes, BW 1000000 Kbit/sec, DLY 10 usec, reliabil...
Hi Peter,
Thanks for your reply, i have Nexus 9396PX model with n9000-epld.7.0.3.I4.5.img. Yes, as you said they are running in VPC and we have configured bgp with almost 10 neighbor to AWS direct connect, also we have L3 SVIs are configured , that'...
Mark,We have nexus 9396 pair in our network, where we have number of bgp sessions and vlan SVI are configured , so my feel is if i reboot the switch during epld image upgrade, it will impact the traffic going through the switch. To avoid that is ther...
