Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've recently installed CUCM 11 in my lab for testing. Everything is working phone, but we're unable to barge into shared lines.
The message on the phone is "No Conference Bridge"
I have a Media Resource Group and the software conference bridge is ...
Hi all, What should be a simple task is proving to be difficult and I really need some help. The Cisco ASA is obviously not a strong point on mine and could do with a point in the right direction. Hopefully this will allow me to learn more about the ...
Hi all, I could really use some help regarding this topic. Please allow me to explain the situation. Ok we have some endpoints that are not Cisco but cisco have developed cop files for CUCM and they are seen as a cisco device and register the same as...
Hi all, Can anyone help? I'm setting this up in my lab and I've never done this before. I have a 2821 which I have several phones registered too. extsions are 5000, 5001, 5002 and 5003. I have an FXO card which is connected to my analogue line. There...
Hi all, I was wondering if someone could give me some help on setting up an E1 PRI link between a 2 call manager expresses? I have a CME on a 2621 and a 2821.I have phones registered to both of them and there is an E1 card in each router connected us...
Just barge. We do not want cbarge. We have trading turrets that we need to test that only support barge. Privacy is off. We have to switch this off and the trading turrets handle privacy locally on the endpoint. Cisco sip phone have their privacy set...
I am using G711alaw, so the software conference bridge should be more than sufficient. I do not need to use an ios or hardware bridge because I am not using g729. Please correct me if I am wrong.
Thanks,
Hey, I've got powered everything up, plugged a device in to the router and can ping both ways now. Thanks for your help. It appears that the issues is now resolved I really appreciate your help. I have learned a lot from you.
I think I was right about the access list; Drop-reason: (acl-drop) Flow is denied by configured ruleEnfield-ASA# packet-tracer input inside icmp 192.168.254.1 8 0 10.1.1.1Phase: 1Type: ROUTE-LOOKUPSubtype: Resolve Egress InterfaceResult: ALLOWConfig:...
