Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
- Customer have existing an ASA software install in ASA5508 but they would like to integrate with RSASecurID for two factor authentication ? So I concern that which component require and subscription level for integrate with RSASecurID for Two factor...
Does 2x10GE port of ASR1001-X support link aggregation ?
Due to in document show that all port on fix ethernet line card and SPA are support.I am not sure that it include that 10G ethernet fix port support or not.
Hi,
I just would like to confirm my understand correct due to I have to use remaining 10GE port on line card WS-X6708-10GE with sup720 in the customer existing device.
- I can use it all 8 port 10GE in WS-X6708-10GE line card but it is not provi...
For more question so I will provide you more information design Firepower 2130 , and proposed catalyst 9400 with sup1 that design to use VRRP or HSRP, but at the nexus5672UP side design for vPC and I design to connect the network diagram as attach ? ...
Hi,
Because the actual traffic between campus and data center is not exceed the 4.75 Gbps throughput ? The failover traffic can use as 8 Gbps, Right ? Is it require to match the bandwidth of data link ?
For one more question if my data traffic is 10Gbps can I use etherchannel bundle interface to config for stateful failover but my switch is 2960X that eight port in bundle is active so my failover link is 8 Gbps. Can I do I and do it have any concern...
Hi,
So sorry that I do not tell you that I have Firepower 2130 , but I have catalyst 9400 with sup1 without stackwise license I have to use VRRP or HSRP, but at the nexus5672UP side I config vPC so Do I have connect the network diagram as att...
