Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What I am needing to do is control what I advertise into BGP. Specifically, I have two groups of connected networks, one cannot be advertised, the other group needs to be advertised. My question is how route maps are processed. One of the members ...
I am trying to work out an ACL to allow nothing to certain external equipment except for source specific multicast from a very select group of sources. My worry is that PIM and IGMP will be blocked by the ACL if not designed properly and I won't rea...
Today one of the 4948s I am responsible for lost communication. When I arrived on-site and consoled in, I found the switch in rommon mode. After checking the bootflash, I power cycled and it booted back up normally and is now running. Every time I...
First time configuring an EtherChannel. Need to do something because current 1 gig link is full during peak times. We are already running data on a port that will be included in the EtherChannel. When we turn this up, will it affect that data flow...
I may be thinking too simplistically here but can you put both connecting interfaces into a passive-interface state while you look for a permanant solution? That should keep them from looking for neighbors but still advertise connected subnets.
I can accept the flash corruption explination. The other 4948s that are doing the same job in other buildings have uptimes of almost two years. I'll keep an eye on this switch and hopefully it will run for another two years. Might get these termin...
