Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm having issues connection a Hawking access point to a Cisco 3560 switch.I am unable to ping the access point from the switch CLI.The interface config looks like this: (interface where AP is connected to)interface GigabitEthernet0/15 switchport tru...
I have ... vlan 1, vlan 10, vlan 20. Internet firewall is 10.0.0.1One switch is configured Layer 3 which does the LAN routing for the network it has one static route (ip route 0.0.0.0 0.0.0.0 10.0.0.1). configured with vlan 10 SVI as 10.0.0.254 and...
I would like to use the ip address-helper feature of my 3560 switch to point 10.1.0.0/24 to my Windows DHCP Server on 10.0.0.0/24 and I am unsure how to go about doing this. Below is a diagram of the network.
Here goes ... the problem:I will have 2 physically seperated buildings on the same lot connected via fiber optics at each end are 3560 switches that will do routing. Each building will be on it's own subnet.Building A is 10.0.0.0/24 VLAN 1 (Which c...
I'm looking at upgrading our T1 to a 10 mbps EoC connection. Currently we have a 506 PIX. What ASA model would be a good replacement. We are a medium size manufacturing company currently with 80 workstations accessing the internet.
Well it turns out this weird problem was the fact i enabled ip routing on one of the switches I wasn't suppose to. Once I turned off ip routing and set the ip default-gateway things are now working correctly.
Makes sense about interfaces needing defining thanks.Next question about the PIX 506E that we use. The existing internal network is 10.0.0.0/24 that we use. What would be the correct NAT statement to use to allow NAT translation of 10.1.0.0/24?Curr...
In the past when I have configured an LACP link between a server and a switch I could see the connection speed on the virtual adapter that is created when teaming on the server. How do I check the speed with 2 switches connected via a LACP Trunk?In ...
Yep, I am getting a wide picture of the many possiblities available. I have been literally learning from the seat of my pants with this cisco gear and LAN technology. The fiber connection has yet to be pulled between buildings (thinking mid January...
THANK YOU SO VERY MUCH! My understanding has really gotten really clearer with your help. Yep I was doing a cut and paste . I aleady have a VTP domain setup so that will take care of propagating the VLAN information once I setup the VLAN on the on...
