I'm having issues connection a Hawking access point to a Cisco 3560 switch.
I am unable to ping the access point from the switch CLI.
The interface config looks like this: (interface where AP is connected to)
interface GigabitEthernet0/15
switchport trunk encapsulation dot1q
switchport mode trunk
macro description cisco-switch
auto qos voip trust
spanning-tree link-type point-to-point
I also could use some help in designing the topology. DHCP / VLAN
Currently I have the AP acting as a DHCP Server. There is also a Windows DHCP Server on the LAN
AP is 10.0.1.240 / 24
Gateway Address is 10.0.1.254 / 24 which is the SVI for VLAN 15
Ideally I would like to set this AP up as follows:
Main SSID would be for LAN and Internet Access
ESSID would by for just Internet Access (Public WiFi) this unit supports VLAN IDs for this.