Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'd like to confirm that the VPN3030, ver 4.1 does not support DMVPN.Also wanted to confirm that the VPN3030 clustering does not work with site to site IPSec VPNs. Thanks,Rick
We'd like to terminate a clear channel T3 to a 3640 (NM-1T3/E3) , with 128mb Dram, a few static routes, 3 active wics, 1 active FE, and cef enabled. I'm wondering what the impressions are of this arrangement, specifically, if the 3640 can handle the...
We're planning to implement basic QOS for VoIP with CBWFQ/LLQ, and wanted to see if unequal cost load balancing would end up affecting the voice quality. Also, since the volume of packets will traverse the different paths disproportionally, the bandw...
Hello. I am running CiscoACS ver 2.6. When adding a NAS for AAA against this server, I have to input the IP address of its serial interface, and not anything else such as the loopback, or the fastethernet. Is this behavior normal? It would be nice to...
Are there any issues with enabling unicast reverse path forwarding on a partially meshed network? If there are 3 sites, (A, B, C) connected like a triangle, would there be issues with enabling it on site A, if it only connects to Site B to reach Site...
The defaults for sending standard/extended community between BGP peers is disabled. For standard communities to be propagated from one site to another in that VRF, send-community both will need to be enabled on all the PE routers the LSP transits, fo...
You can graph the backplane usage with MRTG.Otherwise, is your network multicast enabled, so that multiple ghost sessions wont have a multiplicative effect on the bandwidth consumption? Switches should be enabled for cgmp by default; you'll just have...
If there are no ghost clients on sites off the T1s, as long as you're using sparse, or sparse-dense mode PIM, traffic will not traverse the T1s.HTH,Rick
