Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have Cisco Prime LMS 4.1.I am looking for the way to manage/unmanage one, or a group of serveral, devices just for the DFM module. I've found the way to manage/unmanage the devices completely (for all modules), but that is not what I need.Any id...
Dears,I am working with LMS 4.1 and FDM 4.1.0.If I ask to the Supported Device Finder Portlet about C4503-E (SysObjectId: 1.3.6.1.4.1.9.1.874), it tells that this device is supported by DFM 4.1.0. Nevertheless, in DFM module each one devices appear i...
Hi, I have an access switch C4506. When I try to use "auto qos voip trust" o "auto qos voi cisco-phone" I have the following error:C4506E-CIBII-MUSEO-4(config-if)#auto qos voip trust The policy AutoQos-VoIP-Input-Cos-Policy cannot be attached to the ...
Hi,We have a strange problem with a Catalyst 4503 switch.The switch has a Supervisor II+TS linecard, two PoE users linecards (WS-X4548-GB-RJ45V), and two power supplies in redundancy mode (PWR-C45-1300ACV).We have about 30 IP phones in the switch (mo...
Hi,I'm trying to create a LMS 3.2 IPM Collector, but no source devices appears in the wizard.I have the Auto Mode Enable in the Auto Allocation Settings, and in IPM Devices I can see all my devices.¿Any idea about what I have been missed or wrong?Tha...
Finally, after opening a TAC case, the problem was the file oid2type_Cisco.Conf. It didn't include the OID of several types of devices. Updating this file the issue dissapeared.
