About gbressanin

gbressanin · 05-09-2019

Hi to all,my customer has the wireless bridges for some zones not reachable with the cabling structure.At the moment the bridges are with the AP1242, I'm looking for replace these old AP but I found that in all the new ones are not possible to instal...

gbressanin · 09-22-2016

Hi,I have a stack of 3850 with version software cat3k_caa-base.SPA.03.07.03E.pkg installed.During the test in lab I notice that if I power off the master switch the standby doesn't take the control but reboot , before the reload on the console i see...

gbressanin · 09-22-2015

Hi,I'm not able to find in any documents what "remote" means . What's the difference in the following output between the row with and without "remote"?.Can someone help me ?? sh environment temperatureModule Sensor Temperature ...

gbressanin · 12-23-2009

Hi,I run the DMA on a CM 4.2(3) that i want to upgrade at version 7.1(3). I get thiese errors:***> DATA PROCESSING TESTS REVEALED AN ISSUE WHICH GENERATED THE FOLLOWING EVENT: Sorry. Unable to parse and identify error number. Raw Message fol...

gbressanin · 10-30-2009

Hi,I'd like to know if some one has an installation with Wireless Controller release 6.0.182 and ip phone 7921 release 1.3(3). With these releases the ip phone randomly get the error "Leaving serviced area" not only while roaming but also when it is...

gbressanin · 05-10-2019

Thank you Sandeep

gbressanin · 08-30-2010

Hi Ricardo,sorry but I'm in vacation and read the mail sometime. I also reinstalled the DMA , have you done that?RegardsGiovanni

gbressanin · 05-06-2010

Hi John,attached the config that you required. Contact me if you need more infoRegardsGiovanni

gbressanin · 01-06-2010

Hi Martin,yes I solved the issue , I done at the same time the reinstall of the DMA and tthen I run it disabling the antivirus.RegardsGiovanni

gbressanin · 11-02-2009

Hi Michael Thank you very much for your quick response, It was very appreciatedRegardsGiovanni

Member Since	‎10-18-2002 02:47 AM
Date Last Visited	‎05-15-2019 12:03 AM
Posts	95

User Statistics

User Activity

WIreless Bridge with new Access Point

3850 - active unit failed but standby unit cannot initiate Switchover

Catalyst 4500-E show temperature output

DMA Errors on Call manager 4.2(3) to 7.1(3)

Phone 7921 and WLC/WISM 6.0.182

Re: WIreless Bridge with new Access Point

Re: DMA Errors on Call manager 4.2(3) to 7.1(3)

Re: Voice gaps when roaming with 7921

Re: DMA Errors on Call manager 4.2(3) to 7.1(3)

Re: Phone 7921 and WLC/WISM 6.0.182