Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
hey folks, i'm deploying a 3560 w/ EIGRP and I came across something that I didn't see w/ a couple other 3560's w/ EIGRP I deployed last month - w/ the same code.Right after I issued the 'router eigrp x' command another command followed it unbeknowns...
Looked over the documentation and most of the DHCP snooping posts here, but have yet to see a scenario such as the one that I'm getting ready to roll out…wanna get it correct the 1st time.Here's what it looks like…•Hub / Spoke topology•Hub an...
Hi Everyone, Got a problem - we exhausted both of our local PRI's this morning. Our configuration is setup so that new calls (when the local PRI's are full) will roll over to the LD PRI. What we found this morning was that when this scenario presents...
Hi Everyone,Got a problem - we exhausted both of our local PRI's this morning. Our configuration is setup so that new calls (when the local PRI's are full) will roll over to the LD PRI. What we found this morning was that when this scenario presents...
anyone known where I can find a really good CSD 3.3 Configuration Guide? I found one for 3.2 and the Release Notes for 3.3, but not the Config Guide.Thank you,scott
I would have to dig up the exact config, but a number of years ago I bundled 4 T1's to an ISP and ran a multihop session between their loopback and mine. Never had a problem if one circuit bounced.scott
As you can see i tried both the "universal" and "universalk9" and both gave me the problem.I went to CCO to download a new code this morning and noticed that I really don't have any other options in the....don't think WBD is really going to give me w...
I just wish I understood why one 3560 has the stub issue and the other did not. They are both runnning the same code. The only diff i see here is that the dir is named diff.Router in production (no stub command)--------------------------------------c...
afraid someone was going to say that.... i only had a couple of hours w/ this thing yesterday before a 4pm ship out to the UK. oh well...will give the engineer on the the floor something to do. :)thank you for your help!scott
