Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been struggling with getting my switches to properly register with my on prem SSM. I have followed every guide I can find, as well as looking at solutions on this board, all with no results. I have been able to use the SSM with my DNAC and I...
Has anyone configured a C9200CX to call home to the on prem SSM? The command structure in IOS XE 17 doesn't seem to follow the published documentation. My switch can ping the on prem SSM, so connectivity itself isn't the issue.
I feel this is a fundamental question, but i need to ask as a newbie here. I have been trying to figure out how to edit a switch configuration once it has been discovered and onboarded into DNA Center. Command Runner won't let me use any command to...
When I run the ISE installer, it never gives me the opportunity to set an IP address. It starts the installer automatically. How can I pause the installer and get a static IP set properly so it can download the packages?
I have been trying to get the stacking between a C9300X-12Y and a C9300-48T working. Unfortunately, I have not been able to do so. Both have the same licensing and firmware, so I am at a loss as to why they won't stack properly. Any guidance would...
I did get this functioning (finally). TAC didn't get me there after a few weeks of back and forth, but I discovered the issue which was seriously basic. There was one line of config missing in my switches. What is needed is:aaa new-modelaaa authori...
I am running 17.13.01. The commands I have used (from config t) are as follows:call-homeprofile CiscoTAC-1no destination address http alldestination address http https://<ipaddress>/Transportgateway/services/DeviceRequestHandlerEndlicense smart trus...
If I read this correctly, you are saying there is no way to modify a switch config within DNAC? Lets say all I want to do is add an NTP reference. I would have to create a template of the entire switch config and then push it to the switch?
Looks like I may be just impatient. If I just let the installer run a LONG time, eventually it gets to the right point of the install to allow input. It takes much longer than I expected.
