Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears,
I am asking about the possibility to connect an AP to an ethernet port of a MAP to join a Mesh topology as below
RAP<--Wireless backhaul-->MAP-1<---Ethernet Cable--->MAP2<---Wireless backhaul-->MAP3
I am using Mobility express installed i...
Dears,
We have IW-6300H-AC-I-K9 AP, and we need to connect two antenna AIR-ANT2588P3M-N= to it And I need to know the possibility of doing this: Please note that according to the link https://www.cisco.com/c/en/us/td/docs/wireless/outdo...
We have a project containing ACI and Vxrail, and I heard that there is some issue in connecting ACI to vxrail, and I dont know exactly,
vxrail will have its vmware environment, so I think it will be just connecting the APIC to vcenter, create VDS, an...
I have an issue when creating L3out with interface type of virtual port channel, the path box is empty, although I created interface policy group of type vpc.
The same issue when adding static port of type vpc for application EPG
Dear BB, The router Cat8300 with C-NIM-4X, is in Autonomous mode IOS-XE, the interface is switchport, So I use Interface VLAN method and assign the port in access vlan, instead of BDI
After Investigation, I only for 2.4 band and not for 5 GHz, so If I can not use two directional antenna on the same AP to point to two different MAP.
If I use Omni directional antenna, what is the maximum path length to the next MAP if I use 2.4 GHz,...
Table 4 mentioning indoor only,
As an other note, according to the below post: You can not use two antennas to cover two different area or to speak to two different bridge , Purpose of two antenna connector is for the diversity ,
https://community.ci...
