Mesh topology: MAP connected on MAP ethernet port

[most_ahdy]

Dears,

     I am asking about the possibility to connect an AP to an ethernet port of a MAP to join a Mesh topology as below

RAP<--Wireless backhaul-->MAP-1<---Ethernet Cable--->MAP2<---Wireless backhaul-->MAP3

I am using Mobility express installed in IW6300 AP,  ALL APs are IW6300

[Mark Elsen]

  - @most_ahdy            FYI : https://www.cisco.com/c/en/us/td/docs/wireless/outdoor_industrial/iw6300/software/config/guide/b_iw6300_scg.html#con_1739013

  M.