Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Preparing for Nexus 9k upgrade from 6.x to 7.0(3).l7.4. However i have read due to few caveats, it is good in two stage upgrade i.e. from 6.x to 7.0.(3).l3-l6 etc. and then instal 7.0(3).l7(4).
best regards
Hi Everyone,
A Quick Question, I have two locations (A&B (* Both locations are near by)) with Voice infrastructure (as shown in Pic).
My service provider is same and providing link to me as active/ Standby. In case Location A goes down I 'll be abl...
Hi,
In our Scenario we are going to terminate Edge router (with eBGP/iBGP) on Core/aggregation Switch. Our Servers are also terminated on same switch but in different Vlan.
(Physically)
Servers
|
|
Edge router----Co...
Hi All,
With reference to diagram Switch A & B are on site A and Switch C&D are on Site B (With Vlans extended across). Plan is to run STP (PVST+ ,etc) and It will block Backup link to avoid loopback (Can't create port Channel as both links are diff...
Hi,
I have config like
SwA & SwB (VSS1)---Connected to ---> SwC & D (VSS2)
Now to make are server accessible primarily on VSS1 & secondly on VSS2. Should I run HSRP? Any other thoughts
Thanks
one caveats
■ When upgrading to Cisco NX-OS Release to 7.0(3)I7(4) from 7.0(3)I2(x) or before and running EVPN VXLAN configuration, an intermediate upgrade to 7.0(3)I4(x) or 7.0(3)I5(x) or 7.0(3)I6(x) is required. For further details, pleas...
Thanks Sylvain, recently I punch a case and got almost similar answer and. Cisco said its a cusmatic error. However they didn't guide to disable the sensor.
thanks
Does it make any difference if the routers terminated on same switch or those are terminated on two different switches and switches are interconnected? My DC are connected over Layer2
