Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a p2p xconnect on asr 9000 platform configured as following:l2vpnxconnect group L2_TESTp2p TEST_XCONinterface TenGigE0/0/2/2neighbor ipv4 10.100.100.66 pw-id 1234Is there any way to bring down the line protocol on interface TenGigE0/0/2/...
Hello,I have a MPLS L2VPN between two Cisco NCS 5011 routers. Both of the devices are running 7.11.2. When I am trying to pass packets with TTL value 1 (any packets with other TTL values are passing OK), these packets are filtered:show lpts pifib har...
Hello,I have a NCS 5011 router and I am trying to configure BFD on OSPF. I have a subinterface (hu0/0/0/0.789), the BFD is coming up normally but I cannot set it under 1s. Any insights?sh bfd session int hu0/0/0/0.789 detI/f: HundredGigE0/0/0/0.789, ...
Hello,I recently upgraded an ASR 9904 using the following guide:: https://www.cisco.com/c/en/us/td/docs/routers/asr9000/migration/guide/b-migration-to-ios-xr-64-bit/m-migration-overview.html#id_33482After starting up the eXR software, the console out...
Hello,I have a case where i want to put clients in a different bridge domain based on their (source) MAC-address. In each bridge domain I have the l2 intefaces of each client and also an l2 subinterface of the router acting as the default gateway. Wh...
Hello @Giuseppe Larosa ,Thanks for the answer. I managed to get access to the console of the sysadmin-vm via the aux port of the RSP and the errors that I am getting are the following:inst_agent[4255]: %INFRA-INSTAGENT-4-XR_PART_PREP_REQ : Received S...
Hello,Thank you for your help. In my case the solution was the command "split-horizon group" in the member subinterfaces in the bridge domain configuration (except subinterface with the default gateway). I suppose there was some kind o loop in my top...
So, based on your experience is it a wrong configuration? I thought that using this config a frame that coming with the vlan stack of 1400, 1800 is going to translate to 927, 650 so it will be reachable from the gateway. In the other way the mac addr...
