Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
After upgrading from Jabber 11.1.2 to 11.5.0, Jabber runs fine until I restart my computer. After a reboot a get the following message "The procedure entry point could not be located in the dynamic link library C:\Program Files (x86)\Cisco Systems\C...
So if asked, is this a yes or no question?! I'm working on a P2P right now and the peer has the field on their spec sheet. Never saw the term working with the ASA.
Was there ever a solution to this?
1841 running..
(C1841-ADVSECURITYK9-M), Version 15.1(4)M12a, RELEASE SOFTWARE (fc1)
Also tried (EnterpriseServices), same version.
Command either has been eliminated, or requires other config to be in place, it wou...
