Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm sure people might have come across this problem numerous times previously. However, I was unabe to get something on this page. So posting this. We have a deployment where we are turning on wired NAC with dot1x with MAB as failover. My understandi...
How the subscription based license expiry works? Does the count down start from the day I bought the license or from the day I apply the license on my PAN?
We are using EAP-TLS with MIC certificate for IP phones to be authenticated on wired dot1x. And have configured MAB as a fail back mechanism with dot1x having higher priority/order. Below is a snip from interface config However, we have encountered ...
I understand that apart from Device Admin license we don't need any other other license (base/plus/apex) per service node in a ISE 2.4 distributed deployment. However, I want to double confirm whther we need any kind of extra license while adding few...
Unfortunately the endpoints are on static IP. Even if you configure DHCP it will be authenticated for the first time then once idle timeout occurs, switch will drop and if somebody tries to access the endpoint now, it will fail. So to keep the endpoi...
We are using dynamic VLAN under authorization. All the ports are configured with a dummy vlan and depending upon endpoint type, ISE sends CoA to change it to right VLAN. Tested quite a few config combination. It only works when the port is in open mo...
@poongarg wrote:I still need to check the aaa and radius configuration on your device.Here it is: radius server SRV1address ipv4 10.211.xx.xx auth-port 1812 acct-port 1813key 7 xxxxradius server SRV2address ipv4 10.137.xx.xx auth-port 1812 acct-port ...
