Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I already have a TAC case open on this but I wanted to see if anyone else has run across this...I am deploying new c9800-40's and have a requirement to do flex connect with CWA. I had this set up with my 5520's and it worked without issue but for som...
I'm hoping someone else may have run across this issue and can help... I have an intermittent issue in which machines that are using wired dot1x fail to authenticate properly after being rebooted. We opened a ticket with Microsoft, as the supplicant ...
FYI. I opened a TAC case on this, but thought I'd also post here in case someone has come across this:I realize that in the end, I will likely have to just rename my hosts. I am, however curious about this because the character limitation impedes the...
I am running into an issue where I get a handful of Dynamic Auth Failure errors in ISE. In the results it's showing a CoANAK and the error cause is 200. In the steps it's showing:11204 Received reauthenticate request 11220 Prepared the reauthenticate...
I know this is an old thread but...Had the same problem so I opened a TAC case. The engineer said this is a bug that is only internally visible to Cisco at this time. The only condition they have for it is that it appears on the 9400's with SUP's. Th...
Rich,Thanks for the reply. I am currently doing exactly as you suggested. It appears that the ACL's are improperly applied in this manner. I suspect you are correct in that very few people are using post-auth ACL's in flex connect. However, it's much...
@Mark Elsen Configuration Analyzer came back with nothing related to a WLAN configuration issue. Doing some additional testing I trimmed the ACL down to just deny RFC1918 addresses and permit everything else. This blocked the system from even reconne...
So question about your statement:- Make sure that for flexconntect APs , the necessary VLANs corresponding to WLANs are arriving at the APs through trunkingI have only one VLAN for wireless and all my AP's have always been access ports with no specif...
