Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I have recently migrated from CSM 3.3 to CSM 4.1 on a new server. I have everything configured and working correctly, but the thing that I am missing is how to configure E-mail alerts based on attack severity. I had this configured on the old ...
Hello All. I hope to get some guidance on the following upgrade scenario as the community has provided great insight and assistance in the past.Upgrade scenario - Physical MCS7800 series SW version CUCM 6.1.3.1000-16 with Pub/Sub to Virtual CUCM 8.0...
I have a 3560 switch that has been defined under Phone Tracking>LAN Switch Details section of CER. I had a bad DNS entry pointing two different switch hostnames to the same IP address. I made the correction in DNS to point to the correct switch. C...
Folks, I have followed the thread regarding VMS 2.3 (not)working on Windows Server 2003. I have setup a server in the lab and have done the following:1. Install a fresh copy of Windows Server 2000 and applied SP42. Install VMS 2.33. Test functionalit...
I have just purchased a Cisco IPS 4240 and have it up and running. Have been using the IEV to view IPS information and that works ok. The VMS 2.2 that came included with the IPS will not work with the current Cisco works (LMS 2.5) installation that w...
My call-pickup groups are all in the 8000 range. Do you think this will cause a problem for me? I haven't had any issues yet but when I get up to 8100 range will I have issues? Thanks!
Since my original post, I have built a fresh server following the steps of my previous post and deployed the server in production. I have been running it for over a month without any problems.the VMS box now running on W2K3 is monitoring and updating...
I want to thank you guys for answering my question. After reading your posts and researching based on these posts, I believe that the VMS route will be the way to go in my environment.BTW, I am using v. 4.1 of the IPS.Again, many thanks!
