Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Looking for an explanation as to why one method works over another.Environment:VTA 2.x client (near the latest)CCM 4.1.3sr1MPLS, with 256k voice, >=384k videoTwo locations, each with own clusterLocations on each cluster set to same bandwidth.Codecs s...
Is anyone having any problems with this combination ? Our initial deployment (10+) of 7920's (spring/summmer 2006) yielded no significant problems. Hdwe version 1 or 2, firmware and phone load unknown.Nov/Dec 06 -- we have deployed large numbers (9...
Good evening all,Have two 3750-12S, stacked. After configuring our 10th etherchannel group, all switch ports went down. Did not catch any messages pointing to issue.Very basic config for inter-vlan routing. One port from each switch in stack are gr...
Thanks for the reply. I have reviewed these doc's before, but will take another look at CAC doc.The primary issue is that one of the two call managers involved will have a "VideoOutOfResources" value, as displayed through the RTM --> Locations.As an...
Our issues are not MTP related...voice works fine. We do have a TAC case open, and they are focusing on the camera software... VTA 2.1, or 2.0.3 ....not sure what we're using at the moment.I will say that TAC tested our setup in lab....and had the s...
Have similar problem with CCM 4.1.3sr1.Not sure of phone firmware, but it's fairly current.Bandwidth is not the main issue...when the sites were clustered together, video was fine and the WAN is the same today as then.Any updates on this ??
