I set my map and use the location icons and names, save the map and set it as default but every time I close and reopen the icons are changed back to the IP network generic icons without the names I assigned......

I am getting flap errors on a port that is connected to a desktop, what causes this error?

If I set up a link from a 3548 to a GEIP+ and segment the switch into 3 vlans, what IP should I use on the switch for the default gateway? Also, do I have to set up a native vlan for vlan 1 since it is DOT1Q? I have only used the ISL trunks before ...

I am getting all C's when I try to console in after the switch a 3548 has been up and runnning a few hours, after restarting I can log into the console again no problem......

Upgraded to Windows 2000 and now I can not get CW to work through HP Openview is this a know problem and is there a fix?