Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Cisco 1700 series router and a PIX 506 configured on the network. Both devices have interfaces directly connected to the LAN and WAN. Although I would like to configure the PIX as the default gateway I am unable to due to the fact that th...
Hi,I have a Cisco 2621XM router setup running IOS 12.4(21a), which provides internet connectivity via an ADSL line. The router also has several site to site VPN's and GRE/IPSec tunnels. Connectivity to the sites via the GRE/IPSEC tunnels work without...
Hi,I have a site-to-site VPN setup with a client on pur PIX. The tunnel is currently using the default group policy, so access is only permitted to the customer servers. I would like to grant the customer site http access to one of our internal serve...
Hi,I've setup a GRE tunnel between 2 Cisco routers. I'd like to monitor one of the routers over the VPN tunnel, for bandwidth info. I've tried simply configuring snmp, which doesn't work. Having read up on the subject, it looks like I'll need to setu...
Hi,I am looking to configure QOS on my PIX running version 8.03 of the PIX software.I would like to give priority to VPN tunnel traffic as well as certain other designated traffic, based on an acl. Ideally, I wouldn't want to police all other traffic...
Hi,Thanks for the post. Both devices are equal in terms of their position on the network i.e. both have interfaces that are directly connected to the LAN & WAN, and I was hoping to keep things that way. With your suggestion, there is still the issue ...
Hi,Just an update on this, as a test I've setup an additional IPsec tunnel to an ASA5505 (my home ASA). Connectivity over this VPN works without any problems. I find it quite strange that 3 customer VPN's should display the same problems (dropped pac...
Hi,Once again thanks for the response. I have tried the above, however, I am still experiencing the same problem, having brought the VPN tunnels down.According to the site pre-fragmentation should be on by default. Thanks
Hi,Thanks for the reply. Strangely the VPN tunnels that terminate off the Tunnel interfaces don't have a problem, it's just the non-GRE IPSEC tunnels. I've tried adjusting the mtu sizes on the physical outside interface using the above commands, howe...
