Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI am working on seting up a lab connecting a 3640 router to internet via cable modem, I have attached the network dia and sample config.I am sucessfull getting the IP add assigned to internet facing router Interface from ISP and I can ping google f...
I have 3640, 1700 and 2600 series router I want to implement site to site VPN using SDM the problem is when I log in to SDM I see all the green dots saying IP enable with a check mark, VPN green dot and says feature avilable but not enabled firewall ...
Hi 1.I need to upgrade the site bandwidth from 256kb to 1533kb what are the steps to do it ?2. Also will this change cause any outage on production network ?3. the project read like this This project is to increase the bandwidth at US...
I need to connect a WAP to a switch but the distance is quite big, so planning to connect it via SM/MM fiber using Media Convertor is it possible ? also need suggetion on different mounting types to attach/hang the WAP any other consideration.I have ...
switch ip add is 192.168.1.2 router e0/1 ip add is 192.168.1.1 the strange thing is that router can ping the switch and switch can ping the PC but pc can not ping the router ?I worked it out many times trying to do the config from scratch but it neve...
Hi I am not sure its onboard or seperate how do i fing it I m not at the site also in the network diagram it is shown as a seperate device so what are the sequence of the steps I need to do I guess the service provider have done from their side is it...
Thanks Gamccall,I am supporting the site remotly, also the AP is not New, available at site so need mounting options ?I will use local power to power the AP Thanks...
Thanks Jonthe link u sent me applies for genral (ftp) traffic so help me understand this for VOIP implementation site located far off delay tolerance required is less than 150ms so this delay is taken care of by simply configuring QOS right?
