Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi thereI am new to vpls and trying to get some design advice. We have vpls from the carrier and I am thinking of implement it with ospf as bgp need static peers.The offices are in US,Europe and Asia.I was thinking of two options:a) Setup OSPF local ...
I am trying to remove the following entry but it does not seems to delete on the asa.crypto map vpn xx set security-association lifetime seconds 3600crypto map vpn xx set security-ssociation lifetime kilobytes 4608000These are the only lines in crypt...
Pondering if it is a good idea to load balance between two ISP for our internet connection. We will be using bgp with default route and utilizing our own IP range.Both ISP connections land into a single router and behind it is a ASA. All inside traff...
He everyone,I am new to multicast and have a question regarding receiving the multicast. what is the easiest way to figure out if the data is being sent by the source or not. Any tips will be a big help.Regards
I am adding multiple multicast on switch doing layer 3 routing with upstream routers which holds connection for multicast groups to different firms.The user is connected to the switch and when I try to add multiple rp addresses, it removes the first...
Hi Giuseppe ,Thank you for your precious advice as it is making me realize how much worth netpro is when it comes to getting some advice from people with knowledge on the subject.In the past, I have been using rip,eigrp and bgp. Have not used ospf a...
Hi Giuseppe,Thank you for response. It's definitely helps. For now, I think it will be about 10 sites and the most it will increase will be 20.Should I go with the OSPF only approach? and tie them with areas?Thank youMehdi.
