About linda.blaser1

linda.blaser1 · 12-13-2016

I have 2 Catalyst 3560 switches. Several switches in Bldg A, but only one in Bldg B. I had fiber run between the two buildings. When I connect the 2 3560's using Fiber/GBIC connectors GLC-SX-MM, the network gets flaky and some of the VLAN even go do...

linda.blaser1 · 09-01-2015

What is the difference between the 3650 and 3650G mode switches? Thanks.

linda.blaser1 · 12-13-2016

Here's what I get when they are plugged connected: (I connected both sides with fiber. Hurried and did a sh int gi 0/50 Then disconnected before people noticed they were down. :) Here's what I got: afpicore3560g-01#sh int gi 0/50GigabitEthernet0/50 ...

linda.blaser1 · 12-13-2016

I connected both sides with fiber. Hurried and did a sh int gi 0/50 Then disconnected before people noticed they were down. :) Here's what I got: afpicore3560g-01#sh int gi 0/50GigabitEthernet0/50 is up, line protocol is up (connected) Hardware is G...

linda.blaser1 · 12-13-2016

Before connect the switch make sure 1 the switch in vtp transparent mode Thanks for your help but I’m not sure how to do this. 2 make these switches with higher spanning root priority Would this fix the priority issue: priority-queue out 3 make sure...

linda.blaser1 · 12-13-2016

Unfortunately, I don't have a maint. window. We are a 24/7 operation.

linda.blaser1 · 12-13-2016

Now mind you, I don't have the two connected cuz I don't want to bring users down again.

Member Since	‎09-01-2015 10:19 AM
Date Last Visited	‎11-16-2020 07:20 AM
Posts	14
Total Helpful Votes Received	5

User Statistics

User Activity

Connected 2 3560 Catalyst switches via fiber. Network acts flakey some VLANs down

3650 vs 3650G

Here's what I get when they

I connected both sides with

Before connect the switch

Unfortunately, I don't have a

Now mind you, I don't have