Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've implemented WDS and have AP's associated to the WDS master.All clients associate fine using LEAP.My question is - When you create the ssid "whatever" on an INFRASTRUCTURE ap.is it necessary to specify the type of authentication under the ssid? a...
I have 4 bridges.1 root3 non rootsAll associations are working and they can pass traffic.However after a few hours the root bridge stops passing traffic to the Switch (uplink).I try to ping its IP - times out.If i go to the Non-root side. Console to ...
Probably should of started this thread w/ the following link.Link has several troubleshooting steps to figure out whats going on.http://www.cisco.com/en/US/tech/tk722/tk809/technologies_tech_note09186a008072d9a1.shtml
When you say they were working prior to upgrade... do you mean they worked as Autonomous or they were on an older version of LWAPP code and have now been upgraded to a newer LWAPP/CAPWAP version?On the WLC the AP is trying to join... Can you verify t...
If you've configured both controllers on the WiSM make sure you've added the SSC (the SHA key) to both controllers.can you post the error you're receiving to verify the issue is the same?
Did you use the Cisco Aironet to LWAPP conversion tool.if Yes.Check the directory where the upgrade tool is installed and see if it created a file (.csv) that contains the SSC for the AP. Then manually add that into the WLC under Security and then AP...
