Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, All.What's the difference from STP disabling and portfast?I know portfast didn't meant STP disable, just but change state to forwarding immediately.But portfast can be a cause of network loop.I think this is same to STP disable(for edge port)....
Hey,I'm configuring 802.1x multiple authenticatino with C3560G.Without any timer changes, user's mac address is registered by static on mac address table.The issue is that if authenticated user moves to non-802.1x port, this user can't access network...
Hello,I'm using AIR-AP1232AG.I did ping test to gateway and the result is not so good like below.What should I do for this?Pinging 10.1.1.1 with 32 bytes of data:Reply from 10.1.1.1: bytes=32 time=1ms TTL=255Reply from 10.1.1.1: bytes=32 time=2ms TTL...
In the attached picture.ARP entries for the Internet are stored only on core layer, not on the Router.Router has a configuration for access Internet that NAT and default gateway.And routing for internet on core switches is default gateway as well.Som...
In the configuration of serial interface, there is "ip rip advertise 5". I think this is the default command. I want to know what exactly means. I assume this is related on rip information advertise period. I couldn't find the infomation related this...
Thank you for your respone.Sorry, I can't post it.But I've solved it with "ip nat inside source static" command.Here I have one more question.If I used that command, I can make mapping to specific inside server.But Is there other solution in order to...
Thank you for your response.I didn't connect router to CSU, but I attached DTE cable.But there is still "clock rate 2000000" after I've issued "no clock rate".Shoud I connect it to CSU for delete clock rate?Thanks.
